Installation Instructions

24
Installation
STEP 13 Install the Protector System
®
(continued)
OPTION B WALL INSTALLATION
If additional clearance is needed an extension bracket (not provided) or wood blockscan be used.
Make sure each brackethasthe same amount ofclearance so theywill align correctly.
1. Position the sensor bracketagainst the wall with the curved armsfacing the door. Make sure
there is enough clearance for the beam to be unobstructed. Mark holes.
2. Drill 3/16 inch pilot holes for each sensor bracket and attach the sensor brackets to the wall
using lag screws (notprovided).
3. Slide the carriage boltinto the sloton each sensor.
4. Insertthe bolt through the hole in the sensor bracketand attach with the wing nut.The lenses
on both sensorsshould pointtoward each other. Make sure the lensisnotobstructed bythe
sensor bracket.
Lens
Carriage
Bolt
(Not provided)
No more than
6 inches (15 cm)
1 2
(Not provided)
Wing Nut
3 4
OPTION C FLOOR INSTALLATION
Use an extension bracket (notprovided) or wood block to raise the sensor bracket ifneeded.
1. Carefully measure the position ofboth sensor bracketsso they will be the same distance from
the wall and unobstructed.
2. Attach the sensor brackets to the floor using concrete anchors (not provided).
3. Slide the carriage boltinto the sloton each sensor.
4. Insertthe bolt through the hole in the sensor bracketand attach with the wing nut.The lenses
on both sensorsshould pointtoward each other. Make sure the lensisnotobstructed bythe
sensor bracket.
(Not provided)
I
e
l
l
1 2
Carriage Bolt
Wing Nut
3 4