Installation Instructions

23
Installation
STEP 13 Install the Protector System
®
Be sure power is NOT connected to the garage door opener BEFORE installing the safety reversing
sensor.
To prevent SERIOUS INJURY or DEATH from closing garage door:
l Correctly connect and align the safety reversing sensor. This required safety device MUST NOT
be disabled.
l Install the safetyreversing sensor so beam is NO HIGHER than 6" (15 cm) above garage floor.
IMPORTANT INFORMATION ABOUT THE SAFETY REVERSING SENSORS
The safety reversing sensors must be connected and aligned correctly before the garage door
opener will move in the down direction.
The sending sensor (with an amber LED) transmits an invisible light beam to the receiving sensor (with
a green LED). If an obstruction breaksthe light beam while the door is closing, the door will stop and
reverse to the full open position,and the garage door opener lights will flash 10 times.
NOTE: For energy efficiency the garage door opener will enter sleep mode when the door is fully
closed. The sleep mode shuts the garage door opener down until activated. The sleep mode is
sequenced with the garage door opener light bulb; as the light bulb turns off the sensor LEDs will turn
offand whenever the garage door opener lights turn on the sensor LEDs will light. The garage door
opener will not go into the sleep mode until the garage door opener has completed 5 cycles upon
power up.
When installing the safety reversing sensors check the following:
l Sensors are installed inside the garage,one on either side of the door.
l Sensors are facing each other with the lenses aligned and the receiving sensor lens doesnot
receive directsunlight.
l Sensors are no more than 6 inches (15 cm) above the floor and the lightbeamis
unobstructed.
Safety Reversing Sensor
6" (15 cm) max. above floor
Invisible Light Beam
Protection Area
Facing the door from inside the garage
Carriage Bolt
1/4"-20 x 1/2"
Wing Nut
1/4"-20
HARDWARE
The safety reversing sensors can be attached to the door track, the wall,or the floor.The sensorsshould
be no more than 6 inches (15 cm) above the floor.Ifthe door track will not support the sensor bracketa
wall installation is recommended.Choose one ofthe following installations.
OPTION A DOOR TRACK INSTALLATION
1. Slide the curved arms ofthe sensor bracket around the edge ofthe door track. Snap into
place so that the sensor bracket is flush againstthe track.
2. Slide the carriage boltinto the sloton each sensor.
3. Insertthe bolt through the hole in the sensor bracketand attach with the wing nut.The lenses
on both sensorsshould pointtoward each other. Make sure the lensisnotobstructed bythe
sensor bracket.
No more
than 6 inches
(15 cm)
Carriage Bolt
Wing Nut
1
2
3