Installation Instructions

21
Installation
STEP 10 Install the door control
To prevent possible SERIOUS INJURY or DEATH from electrocution:
l Be sure power is NOT connected BEFORE installing door control.
l Connectdoor control ONLY to 12 VOLT low voltage wires.
To prevent possible SERIOUS INJURY or DEATH from a closing garage door:
l Install door control within sightof garage door, out ofreach of small children at a minimum
heightof 5feet(1.5m) above floors,landings,stepsor any other adjacentwalking surface, and
away from ALL moving parts ofdoor.
l NEVER permitchildren to operate or playwith door control push buttons or remote control
transmitters.
l Activate door ONLY when itcan be seen clearly, isproperly adjusted, and there are no
obstructionsto door travel.
l ALWAYS keep garage door in sight until completelyclosed. NEVER permitanyone to cross
path of closing garage door.
INTRODUCTION
Install door control within sightof garage door, out ofreach of small children at a minimum height of
5feet (1.5m) above floors,landings, steps or any other adjacent walking surface,and awayfrom ALL
moving partsofdoor. For gang box installationsit is notnecessary to drill holes or install the drywall
anchors.Use the existing holes in the gang box.
NOTE: Your productmay look different than the illustrations.
Screw
6ABx1" (2)
Drywall
Anchors (2)
Screw
6-32x1" (2)
HARDWARE
PUSH BUTTON DOOR CONTROL
1. Strip 1/4 inch (6 mm) of insulation from one end of the wire and separate the wires.
2. Connect one wire to each of the two screws on the back ofthe door control.The wirescan be
connected to either screw.
3. Mountthe door control with the hardware provided.
1/4" (6 mm)
1 2 3
MULTI-FUNCTION DOOR CONTROL
1. Strip 7/16 inch (11 mm) ofinsulation from one end of the wire and separate the wires.
2. Connect one wire to each of the two screws on the back ofthe door control.The wirescan be
connected to either screw. Ifyour garage is pre-wired for the door control choose any two
wires to connect,note which wires are used so the correct wiresare connected to the garage
door opener in a later step.
3. Mark the location of the bottom mounting hole and drill a 5/32 inch hole.
4. Install the bottom screw, allowing 1/8 inch (3 mm) to protrude from the wall.
5. Position the bottom hole of the door control over the screw and slide down into place.
6. Lift the push bar up and markthe top hole.
7. Remove the door control from the wall and drill a 5/32 inch hole for the top screw.
8. Position the bottom hole of the door control over the screw and slide down into place.Attach
the top screw.
7/16" (11 mm)
Wall
1 2 3
GANG BOX
6-32x1"
4-5 6
8 7
6ABx1"
Drywall Anchor
DRYWALL
6ABx1"
Drywall Anchor
6-32x1"
GANG BOX
DRYWALL