Instructions / Assembly

35
Operation
Remote Control and Keyless Entry
Pre-programmed remote control included, no need to program the remote.
To add or reprograma remote control, follow the instructionsbelow. Older Chamberlain remote
controlsare NOT compatible,see page 40 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1. Pressand immediately release the Learn button.
2. Remote Control: Press and hold the button on the remote control thatyou wish to use.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the
keylessentry keypad.Then pressthe ENTER button.
The garage door opener lights will flash (or two clickswill be heard) when the code hasbeen
programmed.Repeatthe stepsfor programming additional remote controls or keyless entry devices.
1
2
OR
PIN
? ? ? ?
4
GHI
5
JKL
7
PRS
8
TUV
9
WXY
0
QZ
*
#
ENTER
0
QZ
*
#
ENTER
6
MNO
“click”
“click”
LEARN LED
LEARN Button
To watch a video, go to tinyurl.com/lcsf6xt
HomeLink
®
If your vehicle isequipped with HomeLink,a Compatibility Bridge
TM
(notincluded) maybe necessary for
certain vehicles.Visit bridge.chamberlain.com to find out if a Bridge is needed.
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Pressand hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds).All remote control and keylessentrycodes are now erased.
Reprogram anyaccessory you wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1. Pressand hold the LEARN button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2. Immediately pressand hold the LEARN button again until the learn LED goes out. All codes
are now erased.Reprogram any accessoryyou wish to use.