Instructions / Assembly
21
Installation
STEP10 Install the door control
To preventpossible SERIOUS INJURY or DEATH from electrocution:
l Be sure power is NOT connected BEFORE installing door control.
l Connectdoor control ONLY to 12 VOLT low voltage wires.
To preventpossible SERIOUS INJURY or DEATH from a closing garage door:
l Install door control within sightof garage door, outofreach ofsmall children at a minimum
heightof 5feet(1.5m) above floors, landings,steps or any other adjacentwalking surface, and
away from ALL moving parts ofdoor.
l NEVER permitchildren to operate or playwith door control push buttons or remote control
transmitters.
l Activate door ONLY when itcan be seen clearly, isproperlyadjusted,and there are no
obstructionsto door travel.
l ALWAYS keep garage door in sight until completely closed. NEVERpermit anyone to cross
path of closing garage door.
INTRODUCTION
Install the door control within sight ofthe door ata minimum height of 5 feet (1.5 m) where small children
cannot reach,and awayfromthe moving parts of the door.
NOTE: Your productmay look different than the illustrations.
Screw 6ABx1" (2)
HARDWARE
1. Strip 1/4" (6 mm) of insulation from one end of the wire and separate the wires.
2. Connect one wire to each of the two screws on the back ofthe door control.The wires can be
connected to either screw.
3. Mountthe door control with the hardware provided.
1/4" (6 mm)
1
2 3