Instructions / Assembly

16
Installation
STEP 6 Install the light bulb
To preventpossible OVERHEATING ofthe endpanel or lightsocket:
l DO NOT use short neck or specialtylightbulbs.
l DO NOT use halogen bulbs.Use ONLY incandescent.
To preventdamage to the opener:
l DO NOT use bulbs larger than 100W.
l ONLY use A19 size bulbs.
1. Install a 100 wattmaximum light bulb in the socket.Lightbulb size should be A19, standard
neckonly. The light will turn ON and remain lit for approximately 4-1/2 minuteswhen power is
connected. Then the lightwill turn OFF.
2. Insertbottom lens tabs into slots on chassis.Tilttowards chassis to engage top tabs, then drop
down gently into place (see illustration).
3. To remove,depress both top lens tabs.Tiltlens slightlyoutward and down,then pull out to
clear bulb.Use care to avoid snapping offbottom lens tabs.
4. To remove,depress both top lens tabs.Tiltlens slightlyoutward and down,then pull out to
clear bulb.Use care to avoid snapping offbottom lens tabs.
NOTE: Use only standard lightbulb. The use of short neck or speciality light bulbs may overheat the
endpanel or light socket.
STEP 7 Attach the emergency release rope and handle
To preventpossible SERIOUS INJURY or DEATH from a falling garage door:
l If possible, use emergency release handle to disengage trolley ONLY when garage door is
CLOSED. Weak or broken springs or unbalanced door could result in an open door falling
rapidly and/or unexpectedly.
l NEVER use emergency release handle unless garage doorwayis clear of persons and
obstructions.
l NEVER use handle to pull door open or closed. If rope knot becomes untied, you could fall.
1. Insertone end of the emergency release rope through the handle. Make sure that “NOTICE”
is right side up. Secure with an overhand knot atleast 1" (2.5 cm) from the end of the rope to
prevent slipping.
2. Insertthe other end of the emergency release rope through the hole in the trolleyrelease arm.
Mount the emergency release within reach, butatleast 6 feet (1.83 m) above floor, avoiding
contactwith vehiclesto preventaccidental release and secure with an overhand knot.
NOTE: If it is necessary to cut the emergency release rope, seal the cut end with a match or lighter to
prevent unraveling.Ensure the emergency release rope and handle are above the top of all vehicles to
avoid entanglement.