How to Guide

Operation

Remote Control (continued)

PROGRAM USING THE LEARN BUTTON

1. Locate the Learn Button.

2. Press and immediately release the Learn button. The Learn LED will glow steady for 30 seconds. Within 30

seconds...

3. Remote Control: Press and hold the button on the remote control that you wish to use.

Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry

keypad. Then press and hold the ENTER button.

Release the button when the garage door opener lights blink or two clicks are heard. When replacing the light lens

cover, ensure the antenna wires are hanging straight down.

LEARN LED

LEARN

Button

“click”

1-2 3

To watch a video, go to tinyurl.com/lcsf6xt

HomeLink

If your vehicle is equipped with HomeLink, a Compatibility Bridge

(not included) may be necessary for certain

vehicles. Visit bridge.chamberlain.com to find out if a Bridge is needed.

To Erase the Memory

ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES

1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6

seconds). All remote control and keyless entry codes are now erased. Reprogram any accessory you wish

to use.

ERASE ALL DEVICES (Including MyQ

enabled accessories)

1. Press and hold the LEARN button on garage door opener until the learn LED goes out (approximately 6

seconds).

2. Immediately press and hold the LEARN button again until the learn LED goes out. All codes are now

erased. Reprogram any accessory you wish to use.