How to Guide

35
Operation
Multi-Function Control Panel (continued)
LOCK
The LOCK feature is designed to prevent activation of the garage door opener from remote controls while still allowing
activation from the door control and keyless entry. This feature is useful for added peace of mind when the home is
empty (i.e. vacation).
l Activate: Press and hold the LOCK button for 2 seconds. The command LED will flash as long as the lock
feature is activated and your handheld remote control will not operate your door at this time.
l Deactivate: Press and hold the LOCK button again for 2 seconds. The command LED will stop flashing
and normal operation will resume.
PROGRAM
Any compatible remote controls, wireless keyless entry, or MyQ
®
accessories can be programmed to the garage door
opener by pressing the Learn button.
Push Bar
LIGHT Button
LOCK Button
Command LED
LEARN Button
Remote Control and Keyless Entry*
Pre-programmed remote control included, no need to program the remote.
To add or reprogram a remote control, follow the instructions below. Older Chamberlain remote controls are NOT
compatible, see page 41 for compatible accessories.
PROGRAM USING THE DOOR CONTROL
1. Press the LEARN button on the door control to enter Programming Mode.
2. Press the LEARN button again, the LED will flash once.
3. Remote Control: Press the button on the remote control that you wish to operate your garage door.
Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry
keypad. Then press the ENTER button.
The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed.
The command LED
will flash once.
The command LED will
flash once again.
1
2
OR
PIN
? ? ? ?
3
* Not included with all models.