Installation Instructions

24
Installation
STEP 13 Install the Protector System
®
(continued)
OPTION B WALL INSTALLATION
If additional clearance is needed an extension bracket (not provided) or wood blocks can be used.
Make sure each bracket has the same amount ofclearance so they will align correctly.
1. Position the sensor bracketagainst the wall with the curved armsfacing the door. Make sure
there is enough clearance for the beam to be unobstructed. Mark holes.
2. Drill 3/16 inch pilot holes for each sensor bracketand attach the sensor bracketsto the wall
using lag screws (notprovided).
3. Slide the carriage boltinto the slot on each sensor.
4. Insertthe bolt through the hole in the sensor bracket and attach with the wing nut. The lenses
on both sensorsshould pointtoward each other. Make sure the lens isnot obstructed by the
sensor bracket.
Lens
Carriage
Bolt
(Not provided)
No more than
6 inches (15 cm)
1 2
(Not provided)
Wing Nut
3 4
OPTION C FLOOR INSTALLATION
Use an extension bracket(notprovided) or wood block to raise the sensor bracket if needed.
1. Carefully measure the position ofboth sensor bracketsso theywill be the same distance from
the wall and unobstructed.
2. Attach the sensor brackets to the floor using concrete anchors (not provided).
3. Slide the carriage boltinto the slot on each sensor.
4. Insertthe bolt through the hole in the sensor bracket and attach with the wing nut. The lenses
on both sensorsshould pointtoward each other. Make sure the lens isnot obstructed by the
sensor bracket.
(Not provided)
I
e
l
l
1 2
Carriage Bolt
Wing Nut
3 4