SDS

SAFETY DATA SHEET PN20210327705101
Page 13 of 17 Version Number: V2.0
- The International Civil Aviation Organization (ICAO) Technical Instructions, Packing instruction 965
section ⅠB or 966 section Ⅱ or 967 section Ⅱ (2021-2022 Edition).
- The International Air transport Association (IATA) Dangerous Goods Regulations, Packing instruction
965 section ⅠB or 966 section Ⅱ or 967 section Ⅱ (62
nd
Edition, 2021).
- Special provision 188 of the International Maritime Dangerous Goods (IMDG) Code (Amendment
39-18 Edition).
- The US Hazardous Materials Regulation 49 CRF (Code of Federal Regulations), sections 173-185
Lithium batteries and cells.
- The UN Recommendations on the Transport of Dangerous Goods, Manual of Tests and Criteria 38.3
Lithium batteries.
These products are properly classified, described, packaged, marked, and labeled, and are in proper
condition for transportation according to all the applicable international and national governmental
regulations, not limited to the above mentioned. We further certify that the enclosed products have
been tested and fulfilled the requirements and conditions in accordance with UN Recommendations
(T1 – T8) on the Transport of Dangerous Goods Model Regulations and the Manual of Tests and
Criteria.
Test results of the UN Recommendation on the Transport of Dangerous Goods
Manual of Test and Criteria (38.3 Lithium battery)
No. Test items Test results Remark
T1 Altitude simulation Pass -
T2 Thermal test Pass -
T3 Vibration Pass -
T4 Shock Pass -
T5 External short circuit Pass -
T6 Impact / Crush Pass -
T7 Overcharge Pass -
T8 Forced discharge Pass -
Additional Requirements for air transport:
1. Cells and batteries must be protected so as to prevent short circuits. This includes protection
against contact with conductive materials within the same packaging that could lead to a short
circuit.
2. Cells and batteries must be manufactured under a quality management program.
3. The Watt-hour rating must be marked on the outside of the battery case except those
manufactured before 1 January 2009.
4. Cells and batteries must be packed in strong outer packagings. (Applicable to PI 965 only)
5. Cells and batteries must be packed in inner packagings that completely enclose the cell or battery.
To provide protection from damage or compression to the batteries, the inner packagings must be
placed in a strong rigid outer packaging of one of the packaging types shown below.
6. Each consignment must be accompanied with a document with an indication that:
·the package contains lithium ion cells or batteries;