User's Manual

35
Operation
Remote Control (continued)
PROGRAM A REMOTE CONTROL USING THE LEARN BUTTON
1. Locate the Learn Button.
2. Pressand immediately release the Learn button. The Learn LED will glow steady for 30 seconds.
Within 30 seconds...
3. Pressand hold the button on the remote control that you wish to use. Release the button when
the garage door opener lights blink or two clicksare heard. When replacing the lightlens cover,
ensure the antenna wires are hanging straight down.
LEARN LED
LEARN
Button
“click”
“click”
1
3
2
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1. Pressand hold the LEARN button on garage door opener until the learn LED goes out
(approximately6 seconds).All remote control and keylessentrycodes are now erased.
Reprogram anyaccessory you wish to use.
ERASE ALL DEVICES (Including MyQ
®
enabled accessories)
1. Pressand hold the LEARN button on garage door opener until the learn LED goes out
(approximately6 seconds).
2. Immediately press and hold the LEARNbutton again until the learn LED goes out.All codes are
now erased.Reprogram anyaccessory you wish to use.