User's Manual

Installation

STEP 11 Wire the door control to the garage door opener

HARDWARE

Insulated

Staple

(Not Shown)

1. Run the white and red/white wire from the door control to the garage door opener.Attach the

wire to the wall and ceiling with the staple (notapplicable for gang box or pre-wired installations).

Do not pierce the wire with the staple as this maycause a short or an open circuit.

2. Strip 7/16 inch (11 mm) of insulation from the end of the wire near the garage door opener.

3. Connectthe wire to the red and white terminals on the garage door opener. Ifyour garage is pre-

wired make sure you use the same wires that are connected to the door control. To insertor

release wires from the terminal, push in the tab with screwdriver tip.

RED

WHITE

GREY

7/16" (11 mm)

Staple

STEP 12 Attach the warning labels

1. Attach the entrapmentwarning label on the wall near the door control with tacksor staples.

2. Attach the manual release/safetyreverse test label in a visible location on the inside of the

garage door.