User's Manual

37
Operation
Programming
To Add, Reprogram or Change a Keyless Entry PIN
NOTE: Your new Keyless Entry must be programmed to operate your garage door opener.
USING THE “LEARN” BUTTON
1. Press and release the “learn” button on motor unit.The learn indicator light will glowsteadily
for 30 seconds.
2. Within 30 seconds,enter a four digitpersonal identification number (PIN) of your choice on the
keypad.Then press and hold the ENTERbutton.
3. Release the button when the motor unit lights blink.Ithaslearned the code.Iflightbulbsare
not installed, two clicks will be heard.
1
2
3
USING THE MULTI-FUNCTION DOOR CONTROL
1. Enter a four digit personal identification number (PIN) ofyour choice on the keypad. Then
press and hold ENTER.
2. While holding the ENTER button,press and hold the LIGHTbutton on the Multi-Function Door
Control.Continue holding the ENTER and LIGHTbuttons while you press the push bar on the
Multi-Function Door Control (all three buttonsare held).
3. Release buttons when the motor unitlightsblink.Ithas learned the code.Iflight bulbsare not
installed, two clickswill be heard.
2
1
3
To change an existing,known PIN
If the existing PIN is known,itmay be changed byone person withoutusing a ladder.
1. Press the four buttons for the presentPIN,then press and hold the # button.
The opener lightwill blink twice. Release the # button.
2. Press the new 4-digit PIN you have chosen,then press Enter. The motor unit lights will blink
once when the PIN has been learned.
Testbypressing the newPIN,then press Enter. The door should move.
To set a temporary PIN
You mayauthorize access byvisitors or service people with a temporary 4-digit PIN. After a programmed
number of hoursor number ofaccesses, this temporary PIN expires and will no longer open the door. It
can be used to close the door even after it hasexpired. To seta temporary PIN:
1. Press the four buttons for your personal entry PIN (notthe last temporary PIN), then press and
hold the * button.
The opener lightwill blink three times. Release the button.
2. Press the temporary 4-digitPIN you have chosen, then press Enter.
The opener lightwill blink four times.
3. To setthe number of hours thistemporary PIN will work, press the number of hours (up to
255),then press *.
OR
1. To setthe number of timesthistemporary PINwill work,press the number oftimes(up to 255),
then press #.
The opener lightwill blink once when the temporary PIN hasbeen learned.
Testbypressing the four buttons for the temporary PIN, then press Enter. The door should move.Ifthe
temporary
PINwas setto a certain number of openings, remember that the test hasused up one opening.To clear
the temporary password, repeatsteps 1-3,setting the number ofhours or times to 0 in step 3.
One Button Close: Opener can be closed by pressing only the ENTER button if the one button close
feature has been activated. This feature has been activated at the factory. To activate or deactivate this
feature press and hold buttons 1 and 9 for 10 seconds. The keypad will blink twice when the one button
close is active. The keypad will blink four times when one button close is deactivated.