User's Manual

23
Installation
STEP 13 Install the Protector System
®
(continued)
OPTION B WALLINSTALLATION
If additional clearance is needed an extension bracket(not provided) or wood blocks can be used. Make
sure each bracket has the same amountofclearance so they will align correctly.
1. Position the sensor bracketagainst the wall with the curved arms facing the door.Make sure
there is enough clearance for the beam to be unobstructed.Markholes.
2. Drill 3/16 inch pilotholes for each sensor bracket and attach the sensor brackets to the wall
using lag screws (notprovided).
3. Slide the carriage boltinto the sloton each sensor.
4. Insert the boltthrough the hole in the sensor bracketand attach with the wing nut. The lenses
on both sensorsshould point toward each other. Make sure the lensis not obstructed bythe
sensor bracket.
(Not provided)
No more than
6 inches (15 cm)
1
2
Inside
G
arage
Wall
(Not provided)
Lens
Carriage Bolt
1/4"-20x1/2"
Wing Nut
1/4"-20
3
4
OPTION C FLOORINSTALLATION
Use an extension bracket(not provided) or wood blockto raise the sensor bracketifneeded.
1. Carefully measure the position of both sensor bracketsso they will be the same distance from
the wall and unobstructed.
2. Attach the sensor brackets to the floor using concrete anchors(not provided).
3. Slide the carriage boltinto the sloton each sensor.
4. Insert the boltthrough the hole in the sensor bracketand attach with the wing nut. The lenses
on both sensorsshould point toward each other. Make sure the lensis not obstructed bythe
sensor bracket.
I
nsid
e
G
arage
Wa
l
l
(Not provided)
1 2
Carriage Bolt
1/4"-20x1/2"
Wing Nut
1/4"-20
3
4