(En &® @ BIE 15 10 Ago b Friday. Jae 11, 1999 6:01 PM ®) Radio Shack. Cat. No. 81-2118 Universal Garage Door/Gate Opener Your Radio Shack Universal Garage Door/Gate Opener is a transmitter compatible with most 300. 310, and 390, trued by Chambedain®, Genie®, Lift-Master®, Linear® Moore-O-Matic®, Mulli-Code®, Sears®, and Please note that this 5 Opener! is not compatibly openers or gates, including different bra 1f your system uses code switches, you must program the Opener to match the existing code.
{8 i | BER dn page 2 Bride. Tone 11, 1998 6:01 PM 3) Determine whether your system uses code switches outdoes, depending on your brand, you may have They are usually located on the receiver panel (perhaps under the lamp cover}. The receiver is normally stomachache the garage road or gale operator system, or R may be mounted on a wall and wired 10 the Receiver Anal Su Rutan wines whit pron Bo = Remote Code Switches S. ’ Example of a Sears system with 9 cued switches (white irate the side position): system.
G13S 0m Page § Friday. tune 11. 1999 501 PM Example table showing the settings for a Stanley system with 10 code switches: CLOSE OPEN 33 3313 After you fill in the table, verity that the 5 nl match your system's switch settings. Then hei N “Programming the Opener. : PROGRAMMING THE OPENER Before you begin to program the wr, determine which button you want to use to aerate your system. The either two bunions can be used for additional garage dour or gate operating systems.
@& 21180m Page $ Friday June 111998 6:01 PM Ah} briefly press the smart button {for ne [longer than 3 2. Remove the Phillips screw from the center of the microsecond, then release both buttons. cupboard and pridefully lit out the board and the Programming is complete and the Opener is ready iet" logistic battery shield to open and close your garage door or gate. Test it 3 to make sure it operates your system.
