User Manual

18
PRE-INSTALL NETWORK PROGRAMMINGINSTALL ACCESS CONTROLINTRODUCTION
Gate Access (Wireless)
For use with LiftMaster
®
Security+ 2.0
®
gate operators.
1 Enter Admin Mode
Touch the upper left-hand corner of
the controller display to enter Admin
Mode.
2 Select Outputs and Relay
Select the Outputs tab. Then select the
desired relay on the left-hand side (1
through 4).
3 Press LEARN button on gate
operator
Press and release the LEARN button
on the primary operator. The green
XMITTER LED will light. NOTE: The
operator will time out of programming
mode after 180 seconds.
4 Press LEARN button on gate
operator again
Press and release the LEARN button
again on the primary operator. The
yellow NETWORK LED will light.
5 Select LEARN on display
Select the LEARN button on the
display and the Learn button will go
from green to red. The gate operator
and the controller will beep and the
NETWORK LED on the gate operator
will turn off indicating programming is
successful.
6 Validate
Validate functionality by selecting Test
Relay on the controller display.