User's Manual

Troubleshooting

LED INDICATORS FOR THE WI-FI HUB

WI-FI HUB STATUS LED COLOR LED STATE

Wi-Fi needs to be setup Blue Blinking

NO router communication Green and Blue

Blinking

Wi-Fi setup active Blue ON

Communicating with router Green Blinking

Programming mode Yellow and Green Blinking

Normal operation Green ON

PROGRAM A DOOR SENSOR

To program a new sensor.

1. Use the MyQ App to add a new door sensor.

Press and release BUTTON 1 for door 1 or BUTTON 2 for door 2 on the Wi-Fi hub. The

yellow LED on the Wi-Fi hub will turn off when successfully programmed.

2. Press the Test button on door sensor until the yellow LED on the door sensor turns on.

3. Press the Test BUTTON again on the door sensor and the Wi-Fi hub will beep once for

door 1 and twice for door 2.

The door sensor will not or is not programmed to the Wi-Fi hub.

• Press the Test button on the door sensor (the Yellow LED should blink). If the Yellow

LED on the door sensor does not blink, replace the battery, then replace the door

sensor. After replacing the battery, see Program a Door Sensor below.

The Wi-Fi hub will not operate the garage door opener.

• Ensure the garage door opener is compatible, see page 4.

• Follow the steps to program the Wi-Fi hub to the garage door opener, see page 4.

The remote control(s) will not program to the Wi-Fi hub.

• Verify the remote control is compatible. Visit www.myliftmaster.com for a complete list

of compatible accessories.