User's Manual

7
WIRE AND MOUNT THE TRANSMITTER(S)
NOTE: The transmitter can be wired to 1 or 2 edge sensors.
1. Route the wires from the edge sensor into the transmitter. Connect the wires to the terminal blocks (polarity is NOT
important).
2. Attach the mounting bracket to the gate using the screws provided. If installing on a round surface, use zip ties (not
provided).
3. Reattach the transmitter housing.
4. Snap the transmitters onto the mounting bracket and secure with the screw provided.
WIRE AND MOUNT THE TRANSMITTER(S)
NOTE: The transmitter can be wired to 1 or 2 edge sensors.
1. Route the wires from the edge sensor into the transmitter. Connect the wires to the terminal blocks (polarity is NOT
important).
2. Attach the mounting bracket to the gate using the screws provided. If installing on a round surface, use zip ties (not
provided).
3. Reattach the transmitter housing.
4. Snap the transmitters onto the mounting bracket and secure with the screw provided.
WIRE AND MOUNT THE TRANSMITTER(S)
NOTE: The transmitter can be wired to 1 or 2 edge sensors.
1. Route the wires from the edge sensor into the transmitter. Connect the wires to the terminal blocks (polarity is NOT
important).
2. Attach the mounting bracket to the gate using the screws provided. If installing on a round surface, use zip ties (not
provided).
3. Reattach the transmitter housing.
4. Snap the transmitters onto the mounting bracket and secure with the screw provided.
5
12
34
Review Copy