Manualshelf

User's Manual

ManualsBrandsChamberlain Group ManualsElectronicsBluetooth Wireless Edge
12345678910
5
2
INSTALL TRANSMITTER BATTERIES AND SET EDGE DIRECTION
1. Open the transmitter housing.
2. Install the batteries.
3. Decide the direction (open or closed) the edge will be installed. Set “OPEN/CLOSE” DIP switch to match the direction of
the edge protection.
INSTALL TRANSMITTER BATTERIES AND SET EDGE DIRECTION
1. Open the transmitter housing.
2. Install the batteries.
3. Decide the direction (open or closed) the edge will be installed. Set “OPEN/CLOSE” DIP switch to match the direction of
the edge protection.
INSTALL TRANSMITTER BATTERIES AND SET EDGE DIRECTION
1. Open the transmitter housing.
2. Install the batteries.
3. Decide the direction (open or closed) the edge will be installed. Set “OPEN/CLOSE” DIP switch to match the direction of
the edge protection.
PROGRAMMING
The receiver can learn up to 4 transmitters.
1. Press the learn button on the RECEIVER board. The red LED will come on and the operator control board will beep once
to indicate programming mode. NOTE: Press the learn button again to exit programming mode.
2. Press the learn button on the TRANSMITTER to be learned. The red LED on the RECEIVER will blink 4 times. Press the
learn button on the next TRANSMITTER to be learned. NOTE: Learn mode times out after 60 seconds if no transmitters
are added or the capacity is reached. After each transmitter is learned there will be an additional 60 seconds to complete
programming.
PROGRAMMATION
The receiver can learn up to 4 transmitters.
1. Press the learn button on the RECEIVER board. The red LED will come on and the operator control board will beep once
to indicate programming mode. NOTE: Press the learn button again to exit programming mode.
2. Press the learn button on the TRANSMITTER to be learned. The red LED on the RECEIVER will blink 4 times. Press the
learn button on the next TRANSMITTER to be learned. NOTE: Learn mode times out after 60 seconds if no transmitters
are added or the capacity is reached. After each transmitter is learned there will be an additional 60 seconds to complete
programming.
PROGRAMACIÓN
The receiver can learn up to 4 transmitters.
1. Press the learn button on the RECEIVER board. The red LED will come on and the operator control board will beep once
to indicate programming mode. NOTE: Press the learn button again to exit programming mode.
2. Press the learn button on the TRANSMITTER to be learned. The red LED on the RECEIVER will blink 4 times. Press the
learn button on the next TRANSMITTER to be learned. NOTE: Learn mode times out after 60 seconds if no transmitters
are added or the capacity is reached. After each transmitter is learned there will be an additional 60 seconds to complete
programming.
3
Learn Button
Bouton Apprendre
Botón de Programación
OPEN/CLOSE Dip Switches
OPEN/CLOSE Dip Switches
OPEN/CLOSE Dip Switches
Review Copy