Installation Guide

9
Preparation & Safety
Installer Agreement
What's In the Box
What's In the Door
Wire the Control Panel
Check Power
Set for Programming
Test Operation
Troubleshooting
LED Status
Diagnostics
Repair Parts
Notices
For More Help
Check Power
Test Operation
Power Up
1. Power the door. The Logic board's
Blue LED blinks. The Adapter LED
glows steady Red. The receiver light
at the IR sensor glows steady Green.
2. Press the #3 Door Activation button,
and the doors open.
Basic Function
After programming the myQ® Pet Portal, cameras and Collar Sensor, the Pet
Parent can test the cameras and speaker, as well. They will test:
Activate Program Mode
IMPORTANT: Instruct the Pet Parent to check their Wi-Fi and access the
myQ® Pet Portal app. Promptly, after you activate programming, they will
have up to 1 hour to add devices to their account.
√
√
√
Power
Switch
Logic Board Cover
Button#1
Door
Activation
Button#2
Collar
Activation
Button#3
Door
Activation / Rese
t
1. From the myQ® Pet Portal app, open
the Portal door while inside the
home.
2. As the Portal door starts to close,
wave a pen between the IR Beam at
the threshold center, and the Portal
door reverses open.
3. Hold the Collar Sensor near the Portal
door, and the Portal door opens. The
Portal door closes after the default
time passes.
4. Inspect the camera views standing in
front of each one added.
5. Tap Push to Talk and speak to hear
their voice through the speaker.
6. Repeat steps 1-5 from outside. Basic
operation testing completes.
1. Press the Power Switch on. The Blue LED begins to blink, glows solid,

ashes, then glows solid again.
2. Press and hold the #3-Program button for 5 seconds, and release when
it blinks Blue.The unit is now in Program Mode.
3. The Pet Parent promptly adds the Pet Portal from their mobile device,
then adds cameras, and then the myQ® Pet Sensor.
4. Assure wires are secure within the module when reattaching the
Component Cover and Service Portal Frame,
Infrared Beam
Set for Programming
Remove myQ cover, replace w/
lobic board (global) Use the lower
image w/all callouts