Installation Guide

6
Preparation & Safety
Installer Agreement
What's In the Box
What's In the Door
Wire the Control Panel
Check Power
Set for Programming
Test Operation
Troubleshooting
LED Status
Diagnostics
Repair Parts
Notices
For More Help
Wire the Control Panel
Connect Power
Use the following guide to test power to the module sealed in the door
panel, and install.
1. Place the new door panel upright, close to the intended power outlet on
the job order.
2. Use a plastic putty knife to carefully pry the Service Panel Frame, and
unscrew the Component Cover to access the spooled wire connected
to the myQ® Logic Board. IMPORTANT: Do not pull on the wire
connection.
3. Thread the wire through the Control Panel poke hole, hinge side, on the
job order.
4. Strip 1/4" insulation at the unconnected wire end.
5. Connect the stripped Black wire to NEGATIVE and the stripped Red wire
to POSITIVE on the adapter.
6. Connect the adapter to an extension cord, and plug in to the outlet. The
adapter LED glows red.
√
Hinge Jamb
Wiring
Power Hinge
24V 2A 48W Wall Adapter
With Screw Terminal Ouput
MG Electronics
Part Number: ST242A
Interior Wall
Crimped Wire
Connections
Crimped Wire
Connections
Red
Black
Remove logic
board cover
globally