Installation Manual

12
1
Remove Knockouts
To prevent damage to the CAPXM from moisture or water:
• DO NOT install during rain. Internal components MUST be
kept from of water and moisture.
• BEFORE opening the front cover of the CAPXM, remove ANY
accumulated water from the top of the CAPXM.
To prevent damage to ANY internal components:
• DO NOT attempt to remove the knockouts with a hammer.
Banging on the knockouts may result in shock to the circuit
boards, which could cause permanent damage.
1. Prepare the work surface by laying down a cloth or
other protective material.
2. Lay the CAPXM face down on the protective
material.
3. Identify which knockouts need to be removed
based on your application.
4. Use a center punch tool to remove the knockouts
from the outside of the box inward using an
appropriately sized punch and hammer. NOTE:
Be careful when removing the knockouts to avoid
damaging the CAPXM components.
PRE-INSTALL NETWORKINSTALL ACCESS CONTROLINTRODUCTION
INTRODUCTION PRE-INSTALL NETWORKINSTALL ACCESS CONTROL
INTRODUCTION PRE-INSTALL NETWORKINSTALL ACCESS CONTROL
INTRODUCTION PRE-INSTALL NETWORKINSTALL ACCESS CONTROL
INTRODUCTION PRE-INSTALL NETWORKINSTALL ACCESS CONTROL
E
P
R
R
S W W
R
R
P P
P
E = Electrical Wiring
P = Pedestal Mount
R = Recess/Surface Mount
S = Security+ 2.0
®
Radio Antenna
W = Wi-Fi
®
Antenna