Installation Instructions

Part No. 14169
Rev. May 2013
Page 10 of 12
Fig. 2
All Century, All Premier Series, Titan, Clearvue, Astra only
available as an accessory for other series
Screw covers are installed onto mounting frames to hide the screws and give your opening a cleaner look.
1. Measure and record mounting frame measurements.
2. Cut each length of vinyl screw cover to the recorded mea
surement, using a fine tooth hack saw.
3. Install side mounting frames first. Starting at top of side
mounting frame, place lower edge of screw cover into inner
edge of mounting frame channel, working your way to
bottom. See Fig. 1.
4. Starting at top of side mounting frame, press higher edge
of screw cover into outer edge of mounting frame channel,
working your way to bottom. See Fig. 2.
5. For the header, place lower edge of screw cover into edge of
mounting frame closest to door. Press higher edge of screw
cover into outer edge of mounting frame channel, working
your way across.
Install the handle hardware and closer system as per the instructions provided in the handle hardware kit and the
closer system kit, included with the storm door. Your installation is now complete.
NOTE: Your door may include the Dual AUTO HOLD™ closer, which is shipped in the off position.
To set the AUTO HOLD™ feature follow the instructions on the closer label before installing.
Outside of door
Doorframe
Fig. 1
STEP 10
INSTALLING MOUNTING FRAME SCREW COVERS
STEP 11
INSTALLING THE DOOR HARDWARE
Mounting Frame Measurements
Header mounting frame
Latch mounting frame
Hinged mounting frame
Inner edge of
Mounting frame
Outer edge of
Mounting frame
#8x1¼” Screw
Higher edge
Of screw cover
Lower edge
Of screw cover
Mounting frame
Outside of
door
Screw cover
Mounting frame