Service manual
3.0 Maintenance Guide
19
Figure 13
5. Turn front hand wheel back and forth to make sure it turns freely with no excess play.
6. Replace electrical panel cover.
3.5.8 Line Light Adjustment (All Models)
The line light can be adjusted if necessary as follows:
1. Remove and disconnect the display panel, then remove the top cover.
2. Loosen the three line light mounting screws (Figure 14).
Figure 14
3. Place a white sheet of paper or papers over the entire cut stick and turn the power on to
activate the line light. Note: 24V is being supplied to line light board while power is on.
4. Slide the line light assembly forward or backward to get a single, crisp line.
5. Tighten the screws and turn power off. Replace top cover and display panel.
Rear Collar
Line Light
Mounting
Screws
Front Collar