Service manual

3.0 Maintenance Guide
17
Figure 10
If knife is cutting deeper on one side than the other, use the following procedure to adjust:
1. Flip the cut stick to a new position and raise the knife depth by several turns of the knife
adjusting screw (Figure 10).
2. Slightly loosen the left-most knife screw only (but keep somewhat snug).
3. Place a few sheets of paper over the entire cut stick, and make a cut. Adjust the knife depth
and continue to make cuts until the knife begins to cut through the bottom sheet of paper on
either side.
4. Once the knife begins to cut through the bottom sheet on one side, leave the knife down by
holding in the left cut button while releasing the right cut button and turning off power.
5. Disconnect power cord, remove and disconnect the display panel, then remove the top cover.
6. Slightly loosen the remaining (5) knife screws, keeping them somewhat snug.
7. Adjust the knife leveling screw (Figure 11) that corresponds with the side of the knife which
does not cut all the way through. Tug on the paper while adjusting and stop when the bottom
sheet is cut all the way through.
Figure 11
Viewing Hole
Knife Leveling Screw
Viewing Hole
Knife Leveling Screw
Knife Adjusting
Screw