Service manual

3.0 Maintenance Guide

Figure 3

3.4 Accessing the Electrical Panel (All Models)

SHOCK HAZARD, CAN CAUSE SEVERE INJURY OR DEATH.

DISCONNECT POWER before accessing the electrical panel. See page 6, SAFETY

PRECAUTIONS, for Power Lockout Procedure.

To access the electrical panel for electrical troubleshooting, electrical adjustments, or for access to

the inside of the machine, open the panel as shown in Figure 4 below. First disconnect power cord.

Then remove the front two panel screws. The panel will pivot down. The panel can now slide

forward by tilting the panel up slightly and then pulling forward.

Figure 4

Grease Lead Screw

Grease Guide Shaft

1. Remove front (2) screws. 2. Tilt panel down. 3. Slide panel forward.