Parts List

13
Customer Helpline 01904 727508
www.coreservice.co.uk
Assembly
Install the guard
1. Remove two screws from the
motor housing.
2. Slide the guard over the motor
housing.
3. Re-insert two screws into the
guard and tighten.
4. Place the two ends of the plant guard into two holes on both sides on the motor housing.
WARING!
Take care to have a look at the yellow warning label and rip off before use.
Take great care when doing this as there is a very sharp line blade (14) on the guard.
remowe b
efore use
w
a
rning:shar
p edge
Remove or install the battery pack
WARNING!
Always release the On/Off trigger before insertion or removal of the battery pack.
Remove the battery pack. Depress the button (A) on end of the battery pack, and then remove the
pack (B) from the tool.
Install the battery pack. Align the ribs on both side of the battery pack with the slots in the housing
and slip it into place. Always insert it all the way until it locks in place with a click sound. If not, it
may accidentally fall out of the tool, causing injury to you or someone around you.
Install