Safety Information

20
Customer Helpline 0343 515 1906
General Troubleshooting
Troubleshooting
The following table provides solutions to common problems encountered with the shredder.
Fault Possible Cause Solution
Motor will not start No mains power supply Check the socket, cable, lead
and plug for damage, and if
necessary, have any damage
repaired by qualied repair
personnel.
Overload protection tripped Wait until the motor has cooled
down, then press the Reset
button and restart the unit
Lid of housing not closed
properly
Tightly screw in the housing
interlock
Garden waste is not drawn in Shredding material is too soft Use the pusher or add dry twigs/
branches
Unit blocked See section “Clearing a
Blockage”
Shredding material in discharge
duct
Remove shredding material from
discharge duct
Unit won’t shred properly Blades are blunt Check and turn, sharpen or
replace blades as necessary (see
section “Sharpening, reversing,
replacing the blades” )
Technical Data Table
Technical Data
Specification Value
Nominal power intake 2400W P40
Voltage 220-240 V ~50 Hz
Insulation protection class
II
Degree of protection IP24
Idling speed 3940min
-1
Branch thickness max. 40 mm
Volume of collection bag ca. 50 l
Weight 12 kg
Sound pressure level (LpA) 84 dB(A) KpA=3 dB
Sound performance level (guaranteed) 107 dB(A)