Assembly Instructions
21
Customer Helpline 0343 515 1906
Blade Maintenance
Maintenance
Always handle the plastic blades with care, sharp edges could cause injury. Use gloves.
Plastic blades will wear over time or may break if they hit a solid object. Always replace blades in pairs
when worn or broken.
Carry out the following steps to change the plastic blades:
• Disconnect from the mains electricity supply and wait until the cutting head
13
has stopped
rotating.
• Turn the mower over and rest it carefully on its side.
• Push the plastic blade
15
towards centre of cutting head
13
. (Fig.14) Lift the plastic blade away
form cutting head
• If a plastic blade
15
has broken during operation remove both blades and replace them
immediately. Always replace blades in pairs.
• Fit new plastic blades into the slots
16
at each side of the cutting head and pull into place.
(Fig.15)
Note! Plastic blades must be replaced in pairs to retain balance. Two plastic cutters of the same type
should be tted.
IMPORTANT! Ensure plastic cutters are correctly located. Never t a metal bar balde to this product.
If the blade has broken, it will be difcult to take it off by hand, or even may hurt your ngers, so it is
necessary to wear gloves or other protective equipment to prevent harming your ngers.
Maintenance and Storage
• Replace plastic blades, bolts, nuts or screws, whenever necessary.
• Ask a technical servicing dealer to clean air lter thoroughly and carry out any other service or
repairs required.
• Store in a dry place, out of reach of children.
14
16
15
13
14
13