Instruction Manual

Customer Helpline 0345 640 0800
11
Operating Instructions
7. CHUCK ADJUSTMENT (SEE FIG. D)
To open the chuck jaws rotate the front section of the chuck. Insert the drill bit between
the chuck jaws and rotate the front section in the opposite direction. Ensure the drill
bit is in the centre of the chuck jaws. Finally, firmly rotate the front chuck section in the
opposite directions. Your drill bit is now clamped in the chuck.
8. TORQUE ADJUSTMENT (SEE FIG. E)
(Screw driving force of your drill driver)
The torque is adjusted by rotating the torque adjustment ring. The torque is greater
when the torque adjustment ring is set on a higher setting. The torque is less when the
torque adjustment ring is set on a lower setting.
When drilling in wood, metal, plastic and screwdriver choose the drill position
.
Make the setting as follows:
1 - 4 for driving small screws
5 - 9 for driving screws into soft material
10 - 14 for driving screwdriver in soft and hard wood
15 - 18 for driving screws into hard wood
for heavy drilling
9. DRILLING
When drilling into a hard smooth surface, use a centre punch to mark the desired hole location. This will
prevent the drill bit from slipping off centre as the hole is started. Hold the tool firmly and place the tip of
the bit at the point to be drilled. Depress the switch trigger to start the tool. Move the drill bit into the work
piece, applying only enough pressure to keep the bit cutting. Do not force or apply side pressure to
elongate a hole.
If you want to activate the drill function (For drilling metal wood or plastic), turn the torque adjustment
ring on the drill position.
D E
When drilling in metal, only use HSS drill bits in good condition. Always use a
magnetic bit holder (not included) when using short screwdriver bits. When screw
driving, apply a small quantity of liquid soap or similar to the screw threads to ease insertion.
When drilling in masonry and concrete choose the hammer position .
for drilling in masonry