Instruction Manual

Customer Helpline 0345 640 0800
10
Operating Instructions
2. INSTALLING AND REMOVING THE BATTERY PACK (SEE FIG B)
a) TO REMOVE THE BATTERY PACK
Press the Battery Pack Release Button (8) firmly first and then slide the Battery Pack
out from your tool.
b) TO INSTALL THE BATTERY PACK
Slide the fully charged Battery Pack onto the tool with sufficient force until it clicks
into position.
5. ON / OFF SWITCH
Press the On/Off switch (a) to start and release it to stop your drill.
The on/off switch (a) is fitted with a brake function which stops your chuck
immediately when you quickly release the switch.
WARNING: Do not operate for long periods at low speed because excess heat
will be produced internally.
a
b
B C
3. FORWARD/REVERSE SWITCH
For drilling and screw driving use forward rotation marked “
” (Forward/Reverse
switch (6) is moved to the left). Only use reverse rotation marked “ ” (Forward/
Reverse switch (6) is moved to the right) to remove screws or release a jammed drill bit.
WARNING: Never change the direction of rotation when the chuck is rotating,
wait until it has stopped!
4. SWITCH LOCK (SEE FIG C)
The switch trigger can be locked in the OFF position. This helps to reduce the
6. USING THE SIGHTLIGHT
To turn on the light simply press the on/off switch. When you release the on/off switch,
the light will be off.
possibility of accidental starting when not in use. To lock the switch trigger, place the
rotation control (b) in the centre position.