Instruction Manual
CONNECTION TO POWER
Before connecting, check that the voltage indicated on the appliance (bottom of the appliance)
corresponds with the main voltage in your home. If this is not the case, consult your dealer and do not
use.
This appliance may be fitted with a non-rewirable plug. If you need to change the fuse in a
non-rewirable plug, the fuse cover must be refitted. If the fuse cover is lost or damaged, the plug
must not be used until a replacement is obtained (available from the appliance manufacturer).
If the plug has to be changed because it is not suitable for your socket, or becomes damaged, it
should be cut off and appropriate plug fitted following the wiring instructions. The plug removed
must be disposed of safely as insertion into a mains socket is likely to cause an electrical hazard.
This unit must be earthed. This equipment must be disconnected from the mains when not in use. Do
not allow this unit to be exposed to rain or moisture.
For your own safety read the following instructions carefully before attempting to connect this
unit to the mains.
You should only plug the appliance into a 230V-240V AC, 50Hz supply. Connecting it to other power sources may
damage the appliance.
IMPORTANT
The colors of the wires in the mains lead of this appliance may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows:
The blue wire must be connected to the terminal marked with the letter N or colored black.
The brown wire must be connected to the terminal marked with the letter L or colored red.
The green and yellow wire must be connecting to the terminal marked with the letter E or the earth
symbol. ( ).
If a 13 Amp (BS1363) fused plug is used it must be fitted with a 3A fuse conforming to BS1362 and be
ASTA approved.
If in doubt contact a qualified electrician
WASTE ELECTRICAL PRODUCTS SHOULD NOT BE DISPOSED OF WITH HOUSEHOLD WASTE.
PLEASE RECYCLE WHERE FACILITIES EXIST. CHECK WITH YOUR LOCAL AUTHORITY FOR
RECYCLING ADVICE.
The wires in this mains lead are colored in accordance with the
following code:
BLUE = NEUTRAL
BROWN = LIVE
GREEN + YELLOW = EARTH
Caution
To prevent electric shock disconnect from the
mains before removing the cover