User's Instructions

Assembly and installation instructions
Important – Please read these instructions fully before assembly or use.
Users may become entangled in or
strangled by loose cords or in gaps between
trampoline and enclosure. Keep enclosure
tightly fastened to the trampoline in
accordance with the manufacturer’s
instructions. Failure to properly assemble
and maintain a tight, secure trampoline and
enclosure boundary may result in serious
injury, strangulation, or death.
If you do not follow these guidelines, you
increase the risk of injury or death.
PRIOR TO ASSEMBLING
Before assembly, please ensure that you
have all the parts required to assemble the
product. If you are missing any parts,
please contact our Customer Support
agents.
NOTICE
Please do not use unauthorized
Sportspower parts to assemble the
trampoline. This may damage the integrity
of the product and will void the
manufacturer’s warranty.
DO NOT use electric power tools to tighten
or loosen bolts and screws as this can
damage the hardware.
All nuts and bolts must be checked for
tightness and if necessary must be
retightened.
All spring-loaded (pit pin) joints must be
checked to see that they are still intact and
cannot become dislodged during play.
Check all coverings for bolts and sharp
edges and replace them if necessary.
If self-locking nuts are used, it should be
noted that these are only suitable for one
assembly and must therefore be replaced.
Review all steps before assembly and
read all precautions before using this product.
Failure to do so can result in serious injury or
death.
During periods of non-use, this trampoline and
trampoline enclosure can be easily
disassembled and stored by reversing the
order of installation.
At least two people are required to
assemble the trampoline and
trampoline enclosure.
Protective gloves must be used during
assembly to avoid pinching by the
springs.
Protective goggles must be worn to
avoid injuries to the eyes.
For appropriate use of the trampoline, please
assemble the trampoline in a location that
meets the following conditions:
Adequate overhead clearance is needed. A
minimum of 26.25 ft (8 meters) from ground
level is recommended. Provide clearance for
wires, tree limbs and other possible hazards.
ALWAYS ensure the trampoline is on level
ground with a minimum of 2 meters clear
space from any structure or obstruction such
as fence, garage, house, overhanging
branches, laundry lines or electrical wires.
Place the trampoline on a flat and level surface
before use.
Do not install this trampoline on hard surfaces.
Suitable surfaces include grass or sand.
Use the trampoline in a well-lit area. Artificial
illumination may be required for shady areas.
The trampoline should be installed in an area
where access can be restricted from
unauthorized and unsupervised use.
Ensure there is nothing beneath the trampo-
line that could cause injury or obstruct move-
ment of jump mat.
The trampoline enclosure is only to be used as
an enclosure for a trampoline of a size for
which the enclosure is designed.
The owner and supervisors of the trampoline
are responsible to make all users aware of
practices specified in the use instructions
section.
WARNING
7 8 9 10 11 12 13