User`s manual

CGPrint User’s Manual 19
Note 2: Although the printer return to text mode when bit image
mode printout is completed, line spacing is set to 0 to
enable further output in the bit image mode. Line feed is
required in order to commence text mode output.
For bit image printing, inverted printing is not performed
but normal printing, even if the DIP switch 1 is set to
"ON".
Example: UP-24/X 1 dot line full dot printing
1Bh 4Bh 12h 01h 00h
FFh......FFh
ESC + K + n1 + n2 + n3 total 18
data
4/c. International character set (ESC+R+n )
The following characters are set for a specified country
by ESC+R+n code input.
n country
0 USA
1 France
2 Germany
3 England
4 Denmark
5 Sweden
6 Italy
7 Spain
8 Japan
An n other than the specified n is invalid, and the
previous n becomes valid. n = 0 (America) occurs
when power is applied.
4/d.Character registration (ESC+&+A1+A2)
Individual patterns can be registered by entering the
code ESC+&+A1+A2, then entering the pattern data.
A maximum of 8 characters can be registered, and
any address in the range of 20H to FFH can be used
for the registration. However, if a new pattern is