User`s manual

CGPrint User’s Manual 17
7. CONTROL COMMAND
7.1. Print control commands
1. Printing command (CR)
If selection code CR (0Dh) is inputted, data in print
buffer is printed and paper feed is performed when
serial data is inputted. When graphic (mosaic)
printing is performed, line feed is not performed by
the print command, and graphic printing is allowed
on the next line.
2. Cancellation command for input data (CAN)
If CAN code (18h) is inputted, all data which are
inputted before CAN code (18h) on the same line are
canceled.
3. Enlarged character printing (SO)
Input SO (0Eh) code with arbitrary columns, then the
following data is printed with double width enlarged
characters. The number of columns entered when all
the characters are shown in Table.
UP-24 12 digits
UP-40 20 digits
This function is released by inputting a print
command (CR) or DC4 (14h) code.
4. Escape alphabet control commands
The following function setting occur with the input of
ESC (1Bh) code and the following alphabet code.
Also, n after the alphabet code indicates an 8 bit
binary value. "+" is used as a separator for
convenience and should not
be entered as data.
Note: When an Escape Alphabet Command is inputted in the
middle of a line, data previously entered is printed, then the
previous sequence is terminated.