User`s manual

CGPrint User’s Manual 14
4.7. Self test printing
A self-printing function is in corporate in this product to
enable the printer to check itself. This function works
only in "manual control mode" (DIP4 OFF) and is
triggered by the following procedure.
(1) Set paper to the printer.
(2) Ensure that the ribbon cassette is attached correctly
and turn the power OFF.
(3) Turn ON the power switch while holding the LF
switch down. Release the LF switch after the self-
printing operation has started.
Printing is initiated by this operation. To end self-
printing, turn OFF the printer.
4.8. General notices
- Never operate your printer without loading paper and
ribbon cassette. Any printing without paper and ribbon
cassette may cause damage to printer head.
- Replace ribbon cassette before it is worn with rents.
- Be careful not to drop any foreign matters, such as
paper clips, pin and the like into your printer. Those
can cause mechanical trouble.
- Nothing shall be placed on the radiation vents to the
printer.
- No organic solvent /thinner, benzin or the lie/ shall be
used in sweeping clean the surface of the main body
case.