User`s manual

CGPrint User’s Manual 13
4.5.3. Charge the accumulator
This products has a quick accumulator charger inside. If
the accumulators too low occur insert the output plug of
the AC adapter into the DC jack of the printer. The
lighted lamp indicates the right connection. After 1 hours
accumulators 70% and more than 2 hours needed to
approx. 100% charged state.
Proposition : Always charge the unit overnight when
charging to obtain a full charge. NiCd accumulators have
an inherent "memory". Unless they are fully charged
each time, the accumulators pack's charge life will be
limited. Discharge the accumulators as fully as before
recharging it.
Note 1: If you using CGPrint printer with optionally ordered NiMH
accumulator the "memory" affect not appear, discharge
accumulators as fully as possibility not necessary and the
capacity and printing time with one charge is 60%
higher.
Note 2: If you order the printer NiCd accumlator never use the
printer NiMH accumlator.
4.6. Power managenemt
In most of application which contains printer the printer
works only short time of operation, but it is power ON
under full operation. If the printer works in line powered
mode it isn't problem, but case of battery operation it is,
because the continuously power consumption decrease
the energy of battery.
If DIP-5 switch ON may be turn On the printer DTR
signal. If DIP-6 switch On may be turn On the printer via
IrDA connection.