Specifications

Figure 20: Female Modem Cable Connector: EOL Set to In
Modem Set EOL to Out
To set the modem with the end-of-line selection set to Out, wire the 9-pin connector using solder connections as in
Figure 21.
Note: The following figure shows the 9-pin female connector. The pin numbers on the 9-pin male connector are
reversed.
Figure 21: Female Modem Cable Connector: EOL Set to Out
Table 15: EOL Connections Summarized
For Non-EOL SelectionFor EOL SelectionFC Bus Signal
Terminal 3Terminal 7, Jumper 7-3FC +
Terminal 9Terminal 8, Jumper 8-9FC -
Terminal 1 or 5Terminal 1 or 5REF
Tape BackTape BackSHIELD
43MS/TP Communications Bus Technical Bulletin: Appendix: FC Bus Auxiliary Devices