User Manual

VIII. -- ASSEMBLY OF THE WEAPON

a) Assemble the bolt assembly following the reverse order as described for its

disassembly. Separate the bolt head from the support so as to hide the rollers;

for this, the best method is to introduce the bolt assembly backwards into the

rear end of the receiver and hit it lightly.

b) Introduce the bolt assembly into the receiver in its correct position and let it

slide in until it is at its most forward position. (fig. 19).

c) Rotate the trigger pack until it fits completely onto the receiver.

d) Replace the buttstock introducing the recoil spring and tube into the

receiver. make sure it goes into the recoil spring support tube on the bolt

carrier. Push the assembly forward until the buttstock housing is fully seated on

the receiver..

e) Replace the two buttstock support push pins.

Testing the assembly:

Test that the weapon is correctly assembled. To do this, place the safety in

<<T>> or <<R>>, pull the cocking lever to the rear and let it go forward. The

weapon should close perfectly.

Actuate the trigger: you should hear the fall of the hammer.

file:///C|/WINDOWS/Desktop/version 2 cetme/35.htm [3/23/2002 9:19:55 PM]