User manual

Input Total Edge Rate (2) Without reading (3) 300.000 edges/s
Continuously polling Counter value 35.000 edges/s
Mutli Frame DAQ @ 1 kHz (4) 25.000 edges/s
Mutli Frame DAQ @ 25 kHz (4) 5.000 edges/s
1. Keep voltages on Trigger I/O below Maximum Input Voltage to prevent CEBO-LC from damage. This is
also true, if CEBO-LC is unpowered.
2. Keep the total number of edges below the Max limit, to avoid missing edges.
3. Counter value is only checked, after counting events have been disabled.
4. Input frame consisting of Analog Input 0 & counter value.
Specifications - Constant Current Source 200µA
Parameter Condition Min Typical Max Units
Absolute Accuracy(1)
~25°C; RSpecifications -
Constant Current Source
10µA
Parameter Condition Min Typical Max Units
Absolute Accuracy(1)
~25°C; R(1) Compared to
calibration data stored in
flash.Specifications - 5
Volt Output
Parameter Condition Min Typical Max Units
Typical Voltage 5 volts
Output Voltage
Accuracy
±5 %
Load Voltage
Regulation(10% to
100% full load)
15 %
Output Ripple and
Noise
50 mV
Maximum Current (1) -40°C 140 mA
-20°C 120 mA
0°C 110 mA
23°C 100 mA
40°C 80 mA
62/63