User manual

37 GND(1) 38 T-LED(3) USB status and traffic LED
39 P-LED(3) Power supply status and indicator LED 40 GND(1)
1. GND pins are internally connected.
2. 5V Power Outputs are internally connected. A total of 100mA can be sourced.
3. T-LED and P-LED are general purpose digital I/Os directly connected to the microcontroller. With
normal firmware, these are used to drive status LEDs on the IO-Board through a series resitor located
on the IO-Board.
Specifications - Vcc/Vss-Output
Parameter Conditions Min Typical Max Units
Typical Voltage No-load ±12 volts
@ 2,5mA ±??? volts
Maximum Current ??? mA
36/63