User manual

Parameter Condition Min Typical Max Units
Absolute Accuracy(1)
~25°C; RSpecifications -
Constant Current Source
10µA
Parameter Condition Min Typical Max Units
Absolute Accuracy(1)
~25°C; R(1) Compared to
calibration data stored in
flash.5 Volt power supply
outputCEBO LC has two 5V
power supply outputs. You
can use them to supply
sensors, signal conditioners
or any other circuit to save
an additional battery or
wall-plug.
One is located at the "5 Volt"
screw terminal, the other is
available at pin 14 of the
25pin D-Sub connector.
Both 5V outputs are
internally connected and
fused by a self-resetting
100mA fuse. The 5 Volts do
not come from the USB plug
directly. There is an isolated
DC/DC converter inside
CEBO LC. The GND
reference is the level of the
CEBO-LC GND signals. The
PC GND is isolated. Do not
try to connect a 5 Volt
source to this output.
CEBO-LC is sourced from
USB and does not need an
additional power supply.
Specifications - 5 Volt
Output
Parameter Condition Min Typical Max Units
Typical Voltage 5 volts
Output Voltage
Accuracy
±5 %
32/63