Safety Instructions

8
Engaging the Safety
Push the safety up to the Safety-On position (Fig. 5) until the red warning dot is covered.
The safety in this position blocks the trigger mechanism and slide, thus preventing the pulling
of the trigger and operating the slide.
Since the trigger mechanism has been specifically adjusted, it is possible to move the
safety onto the "SAFE" position even if the hammer is placed on the safety notch. In this case,
however, it is strongly not recommended to engage the safety because the trigger mechanism
might be damaged when cocking the hammer by force or pulling the trigger. If damage to the
trigger mechanism occurs, let it be repaired by a certified gunsmith.
Besides the method previously described it is possible to put the pistol into a safety mode
and still be ready to fire immediately:
Load the pistol. Grasp the grip, POINT IN A SAFE DIRECTION. With a thumb press on
the grooved area (thumb piece) of the hammer, pull the trigger and release the hammer slowly
forward (Fig. 6) until it rests on the action or safety notch of the hammer. Release the trigger.
Practise this operation very carefully to avoid an accidental discharge! We strongly
recommend to practise this operation beforehand with the pistol unloaded!
In this state the pistol is safe for all normal handling and at the same time ready for
immediate use.
Please remember that the safest way to secure a pistol is to unload it and store it in a
safe place!
Sight Adjustment
The pistol sights were zeroed in at the factoryt at a distance of 25 m so that the mean
point of impact approximately conforms to the point of aim.
The windage can be corrected by shifting the rear sight within the dovetail. Prior to the
adjustment it is necessary to loosen the screw securing the rear sight against falling out. Once
the rear sight has been adjusted it is necessary to tighten the screw again and secure it with
the application of the Loctite 243. Elevation can be corrected by turning the screw.
In case of a requirement, there is an option to exchange the usual rear sights for another
sight of a suitable type, or as the case may be to also exchange the front sight, which is
secured by a roll pin. These adjustments should be entrusted to a competent gunsmith.
Setting the magazine catch
The finger piece of the magazine catch can be set in three positions. When you choose
the desired position, secure the screw in the thread using medium strength Loctite 243
threadlocker.