Safety Instructions

Removal of the Magazine

Grip the pistol in your right (left) hand and by the thumb (middle finger) depress the

magazine catch (Fig. 2). The magazine disengages and falls out of the frame. This pistol

model is equipped with the user type magazine catch which can be reversed by gunsmith for

the right or left hand operation.

Magazine Loading

With the open end uppermost, grasp the magazine in one hand. Place a cartridge on

the magazine follower. Press the cartridge down and back until it touches the rear flat edge

of the magazine. Place the next cartridge on top of the previous cartridge and press down

and back. We recommend that when some cartridges are already loaded in the magazine,

depress them slightly with the thumb of the hand which holds the magazine.

The number of cartridges can be checked through the inspection holes in the sides of

the magazine. Do not try to exceed the magazine capacity - doing so can cause a feeding

failure.

Pistol Loading

ALWAYS MAKE SURE THE PISTOL IS POINTED IN A SAFE DIRECTION WHEN LOADING!

Insert a loaded magazine and ensure that it has engaged the magazine catch.

Hold the pistol by the grip with one hand, and with the thumb and index finger grasp the

serrated finger grips on both sides of the slide. Retract the slide to the stop and allow it to

snap forward (Fig. 3). This procedure cocks the hammer and inserts a cartridge into the

chamber. The pistol is now ready to fire. If you do not intend to fire immediately, ensure the

pistol safety by some of the methods mentioned in the section: Engaging the Safety Mode or

as per section Decocking.

Reloading During Shooting

When the last cartridge has been fired the slide will stay to the rear. Remove the

emptied magazine and replace it with a loaded one. Thumb down the slide stop with the

shooting hand (Fig. 4), or with the other hand draw back the slide and allow it to snap

forward. The pistol is again loaded and ready to fire.

Unloading the Pistol

ALWAYS MAKE SURE THE PISTOL IS POINTED IN A SAFE DIRECTION!

- Remove the magazine

- Draw back the slide and verify the last cartridge has been extracted from the

chamber and ejected

- Let the slide snap fully forward

- Depress the trigger (dry fire)