User manual

Figure 39: Select Network
If using one of the networks on the form click on it and click OK. This will cause the cellular parameters
in the GPS207S_ExPwr main form to be updated with these values. If the network being used is not in the
list you will have to contact the cellular provider to obtain them.
4.5.2 Communication Parameters
The Communication Parameters contain the information required to send data to Power-Trak3 or to
FleetLinc. There are three fields: Unit Number, IP Address and Port.
4.5.2.1 Unit Number
The Unit Number is a unique identifier that enables the software to determine which device is which. It is
very important that a unique number be programmed into each GPS-207DC. If using FleetLinc the Unit
Number must be provided by CES Wireless Technologies.
4.5.2.2 IP Address
The IP Address of the software (i.e. Power-Trak3 or FleetLinc) should be entered here. This is the IP
Address to which the GPS-207DC will send packets to.
4.5.2.3 Port
The Port number used to communicate with the server should be entered here. This port should match the
configuration of the software on the server. The default value is 2400.
4.5.3 GPS Configuration
The GPS-207DC can be configured to report as a static asset, where it will report only at the programmed
intervals (one interval while on external power and one interval while on internal battery power). Or it
can be programmed as a motion asset, where it can be programmed to report at one interval while
stationary or a different interval while in motion. In addition, the GPS-207DC can be programmed to
report at different rates based upon its use of external or internal battery power.
© CES Wireless Technologies Corp – 2012 Page 24 of 28
Figure 40: GPS Configuration, Static Asset
Parameters