Instruction manual
Connect Systems Inc. -Model TP-154 Page 9
The top bold line identifies the item you may wish to program and
the syntax to use for programming followed by the syntax to use to
read this parameter back to either the front panel display if
programming locally or to your CD-2 if programming from a remote
site.
The subline tells you everything you need to know to program this
particular parameter. The first information lets you know the
allowable range for mm and that if you can enter zero to disable
this parameter altogether. In parenthesis the actual range of
adjustment is indicated. If you multiply the value you enter (mm)
by the step size you will have the resultant time. The information
in brackets [mm = 3 = 30 Secs] is how the TP-154 is programmed
when shipped from the factory.
Example: You wish to set the Stuck Mic. Activity Timer to 60
seconds for all users on the system. First determine the value for
mm. This would be 6 (6 times the step value of 10 seconds equals
60 seconds. The desired value). To make this modification, enter
the following sequence on your local or remote DTMF keypad:
*000#22#06#. (Note the leading zero which must be used)
To read this parameter back on the local display or on your CD-2
simply send: *000#22*.
Resetting your position: If you are distracted or have a lapse and
forget where you are in the middle of a command sequence simply
send * three times (***) and start the command sequence over
again. Example: You have just entered *000#22#0 and suddenly you
forget where you are. Simply send *** and begin inputting the
command over again.
Be organized. We recommend thinking through what you want to
program and then writing down the entire sequence of codes you
must send including programming mode access code at the beginning
and exit code (####) at the end. You may send a request to display
any data you wish to see on the local display or CD-2 at any time
while in programming mode.
_______________________________________________________________
| |
| TABLE 1 CW ID CHARACTER CODES |
|_______________________________________________________________|
| A = 0 | G = 6 | M = 12 | S = 18 | Y = 24 | 5 = 30 | WORD |
| B = 1 | H = 7 | N = 13 | T = 19 | Z = 25 | 6 = 31 | SPACE= 36|
| C = 2 | I = 8 | O = 14 | U = 20 | 1 = 26 | 7 = 32 | |
| D = 3 | J = 9 | P = 15 | V = 21 | 2 = 27 | 8 = 33 | SLANT |
| E = 4 | K = 10 | Q = 16 | W = 22 | 3 = 28 | 9 = 34 | BAR = 37 |
| F = 5 | L = 11 | R = 17 | X = 23 | 4 = 29 | 0 = 35 | |
| | | | | | | MESSAGE |
| | | | | | | END = 38 |
|_______|________|________|________|________|________|__________|
| |
| e.g. CW ID message desired is 'CSI' Enter 2, 18, 8, 38 |
|_______________________________________________________________|