Instruction manual

Connect Systems Inc. -Model TP-154 Page 15

COURTESY TONE DELAY *000#31#mm# *000#31*

mm 01-99 (.01-.99 Sec's - 10 Ms/step) [mm = 10 = 100 Ms]

Delays courtesy beep after mobile drops his carrier.

SYSTEM CW ID INTERVAL *000#32#mm# *000#32*

mm 01-99, 0 to disable (1-99 Min's - 1 Min/step) [mm=0=Disable]

Determines how often the system will send its callsign when the

system is not in use.

USER CW ID INTERVAL *000#33#mm# *000#33*

mm 01-99 0=disable (10-990 Sec's - 10 Sec/step) [mm=0=Disable]

A subscribers callsign is sent five seconds after picking up the

system and then every "CW ID Interval" thereafter. If hangtime

is allowed to drop, CW ID timing starts over five seconds after

picking up the system again.

CW ID SPEED *000#34#mm# *000#34*

mm 04-10 (Increase mm for slower code speed) [mm=05=20 WPM]

CWID SEQUENCE CHARACTER 1 *000#35#mm# *000#35*

CWID SEQUENCE CHARACTER 2 *000#36#mm# *000#36*

CWID SEQUENCE CHARACTER 3 *000#37#mm# *000#37*

CWID SEQUENCE CHARACTER 4 *000#38#mm# *000#38*

CWID SEQUENCE CHARACTER 5 *000#39#mm# *000#39*

CWID SEQUENCE CHARACTER 6 *000#40#mm# *000#40*

CWID SEQUENCE CHARACTER 7 *000#41#mm# *000#41*

CWID SEQUENCE CHARACTER 8 *000#42#mm# *000#42*

CWID SEQUENCE CHARACTER 9 *000#43#mm# *000#43*

CWID SEQUENCE CHARACTER 10 *000#44#mm# *000#44*

See Table 1. [CHAR 1 - CHAR 10 are defaulted to 38]

CW ID characters and corresponding mm values may be obtained

from Table 1. The entry immediately following your message

must be 38 which means "end of message". Example: To program KYZ

2584 the following mm sequence is required 10 24 25 27 30 33 29

CARRIER DROP DELAY *000#45#mm# *000#45*

mm = 00-99, (0 - .99 Sec's 10 Ms./step) [mm = 99 = .99 Sec's]

Adjusts how long carrier remains on after CTCSS/DCS drops at end

of hangtime. Keeping the carrier on quiets the mobile while the

mobile CTCSS/DCS decoder is dropping and allows the repeater to

go off without a squelch tail heard. The default value is .99

seconds and probably will not need to be changed.

Note: The carrier drop delay is additive to hangtime and in

effect increases the total beyond the value set for hangtime.