Instruction manual

Connect Systems Inc. -Model TP-154 Page 14
SQUELCH TAIL LENGTH *000#20#mm# *000#20*
mm 00-99 (0-99 Ms - 1 Ms/step) [mm = 0 = 0 Milliseconds]
Set to 0 for minimum tail. Only used if the receiver has a poor
squelch and can stop word clipping by adding squelch delay. If
there is a tail noise when set to 0, it is caused by slow
squelch response in the receiver. The TP-154 does not add any
more tail than is inherent to the receivers squelch if set to 0.
CTCSS/DCS HOLD DELAY *000#21#mm# *000#21*
mm 3-99 (.3-9.9 Sec's - .1 sec/step) [mm = 30 = 3 Sec's]
Use the lowest setting possible without introducing talk off.
Fills the missing gap when CTCSS/DCS decoding momentarily
falters due to overmodulation, momentary weak signal etc.
STUCK MIKE ACTIVITY TIMER *000#22#mm# *000#22*
mm 01-99, 0=disable (10 sec/step) [mm = 18 = 180 Sec's]
DCS ENCODE POLARITY *000#23#J# *000#23*
0 = NORMAL, 1 = Inverted [mm = 0 = Normal]
Corrects transmitted DCS Polarity.
DCS DECODE POLARTIY *000#24#J# *000#24*
0 = NORMAL, 1 = Inverted [mm = 0 = Normal]
Corrects received DCS polarity.
HOG PENALTY TIME *000#25#mm# *000#25*
mm 06-99 (60-990 Sec's - 10 sec/step) [mm = 18 = 180 Sec's]
HOG IDLE TIMER *000#26#mm# *000#26*
mm 02-99 (20-990 Sec's - 10 sec/step) [mm = 06 = 60 Sec's]
HOG TIMER *000#27#mm# *000#27*
mm 06-99 (60-990 Sec's - 10 sec/step) [mm = 18 = 180 Sec's]
See DEFINITION OF TERMS for information about Hog Penalties.
COR OR DCS/CTCSS OPERATE *000#28#J# *000#28*
J = 0 = DCS/CTCSS, 1 = COR [J = 0 = DCS/CTCSS]
NOTE: The operating parameters for carrier operation are
programmed in the user No. 001 file.
RESPONSE DELAY TO CD-2 *000#29#mm# *000#29*
mm 00-99 (0-9.9 Sec's - .1 sec/step) [mm = 10 = 1 Sec.]
Delays CD-2 data transpond to give your base time to return to
receive after entering a command.
PROGRAMMING MODE ACCESS CODE *000#30#mmmmmm# *000#30*
(Code must be precisely six digits) [mmmmmm = 123456]
This code must be used to enter programming mode locally or over
the air.