Instruction manual

Connect Systems Inc. - Model 9800 Page 15
1.6. Disconnect Code
0 = # Down
1 = # Plus Connect Code
DEFAULT: 0 = # Down
Choose the patch disconnect code. Enter 0 to select # down in
most applications. Or enter 1 to select # plus the connect code
digits that were selected on line 1.4.
1.7. Five PTT Autodial
1 = Enable
0 = Disable
DEFAULT: 0 = Disable
If enabled, five presses of the mobile Mic button (at about one
press second) will automatically dial the phone number stored in
speed dialer memory location No.1. Five subsequent presses will
cause a disconnect. This feature does not operate in sampling
simplex or, with external connection method.
1.8. Dialing Mode
1 = Tone
0 = Pulse
DEFAULT: 1 = Tone
Select how the 9800 will dial your phone calls. Note that tone is
much faster if you are in a touch-tone telephone exchange. (The
DTMF tone is fully regenerated).
1.9. Access Delay
Select 1-9 (1-9 seconds)
1 sec increments per step
DEFAULT: 3 = 3 secs
Access delay is a user selectable delay to compensate for PTT
hang after pressing a DTMF key on mobile and portable radios.
Select a value that allows you to hear all of the CW ID and/or
dialtone without clipping.
2.0. Manual Dialing
1 = Enable [2.1.]
0 = Disable [2.6.]
DEFAULT: 1 = Enable
Select disable if dialing should only be allowed from the speed
dialer memory.
2.1. Toll Restrict Digit Counting
1 = Enable
0 = Disable
DEFAULT: 0 = Disable
Enables/disables toll restrict digit counting. If enabled, a
number exceeding ten digits cannot be dialed.