Instruction manual

Connect Systems Inc. - Model 9800 Page 13
Note: This parameter has nothing to do with pulse dialing.
0.7. Activity Timer Mode
1 = Standby [1.4.]
0 = Disconnect [1.4.]
DEFAULT: 1 = Standby
Choose how the activity timer operates in VOX mode. In "Standby",
landline activity exceeding the timer limit drops the patch into
stand-by (off the air). Pressing * in the mobile restores normal
operation. Select "Disconnect" if you prefer the patch to
disconnect upon exceeding the activity limit. (The activity time
is set at line 2.6.)
DUPLEX MODE PARAMETERS
0.8. Semi-Duplex Privacy Mode
1 = Enable
0 = Disable
DEFAULT: 0 = Disable
In privacy mode, the mobile side of the conversation is not re-
transmitted. Thus eavesdroppers only hear one half of the
conversation which provides some voice privacy.
0.9. Repeater Controller
1 = Enable
0 = Disable [1.4.]
DEFAULT: 0 = Disable
1 - Selects Duplex Patch with Repeater controller.
0 - Selects Duplex Patch without Repeater controller.
1.0. Repeater On/Off Control Code
Enter any three digits: xxx
protocol: #xxx = ON
##xxx = OFF
DEFAULT: 456
Select any three digits as an over the air repeater on/off
control code. Press # plus the three digits to turn on the
repeater. Press ## plus the three digits to turn off the
repeater.
1.1. Repeater Mode CW ID Interval
0 = Disable
Select 1-99 (.1-9.9 minutes)
.1 min increments per step
DEFAULT: 30 = 3 minutes
Choose the CW ID interval that you prefer for repeater mode. Or,
disable repeater mode CW ID by entering 0. The CW ID interval is
equal to .1 minutes times the number entered.